![]() Take a horizontal door batten and on each end apply PVC glue. Once you have your battens cut to size you can make the coop doors.Įach coop door is made from two vertical door battens and two horizontal door battens. The final touches are the most important ones! Step 1: Cutting and Fixing the Coop Doors Now you have a finished coop, but, without the detail. Right Side Panel – access hole of 24” wide and 14” high (optional)Ĭhapter 4: The Final Touches (Painting, Fencing, Nesting Boxes).Gable Panel – ventilation hole of 8” square (towards the ridge).Coop Entrance Panel – opening hatch of 14” wide and 18” high (in the middle).Once the coop has been paneled it is time to cut all of the openings into the panels such as the coop door, nesting box, and cleaning access: Now fit the front panel to the coop frame. Now, there is one remaining piece of paneling to measure cut and fit the front panel. Cut the panels from your Oriented Strand Boards, using the cut table above, and proceed to countersink and then screw. Let’s start with the gable panel and entrance panel. Now it’s time to fit two more panels into the coop. Proceed to countersink and then screw the floor into the frame. Now the floor has been inserted, screw the floor panel into the frame of the coop. ![]() Once the side panels are fitted, you are going to fit the floor panel into your coop. After you have finished countersinking the side panels, you can screw them to the coop. You should make sure your coop has the following for each hen.Ĭut the 5 panels required using the sizes specified above.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |